T99 Karst Hydrology: New Insights of Dynamic Aquifer Systems
Monday, 26 September 2016
8:00 AM - 12:00 PM
Room 504
3D PRINTED KARST LIMESTONE CORE FOR APPARENT HYDRAULIC CONDUCTIVITY MEASUREMENT UNDER NON-DARCIAN FLOW
Paper number: T99-13
Program: Technical Sessions
Time: 11:05 AM – 11:20 AM
Authors
-
Nicholas PilarFlorida International University, Miami, FL
-
Sade' Maria GarciaLouisiana State University, Baton Rouge, LA
-
Lee J. FloreaBall State University, Muncie, IN
Abstract
To circumvent this last challenge, we created a 3-D printed 25-cm long x 10-cm diameter core based on computed tomography of a rock sample and made K measurements on it. We previously reported on using high viscosity glycerol to measure true hydraulic conductivity at low Reynolds numbers and found K = 13.1 +/- 3.9 m s-1 (Garcia, 2013). In addition, we made Lattice Boltzmann simulations of flow in the core and computed a nearly identical K (14.8 m s-1).
The high viscosity fluid K measurements did not extend into the non-Darcian flow regime, but Lattice Boltzmann calculations were able to predict the effects of non-Darcian flow up to hydraulic gradients of approximately 10-3; this allowed fitting a Forchheimer model to the simulation results that can estimate apparent K at any gradient.
The current work uses water to measure apparent K at higher gradients (approximately 10-3 to 10-1) and Reynolds numbers. Results are consistent with the Forchheimer model based on Lattice Boltzmann simulations and show about an order-of-magnitude reduction in apparent K as gradients exceed 6 x 10-3 and Reynolds numbers exceed 40,000. Another factor of 2 reduction occurred at gradients approaching 10-1 and Reynolds numbers of 220,000.
These results experimentally confirm a dramatic 20-fold reduction of apparent hydraulic conductivity due to non-Darcian flow, which was previously only predicted on the basis of Lattice Boltzmann simulations. Ks at extreme low and high gradients and Reynolds number regimes expected in these rocks have now been measured. Intermediate gradients from about 10-5 to 10-3, which are most relevant to regional aquifer behavior, have not yet been accessible to laboratory quantification and will likely require intermediate viscosity fluid substitution, or measurement of head differences using very high resolution transducers or laser interferometry.
Geological Society of America Abstracts with Programs. Vol. 48, No. 7
doi: 10.1130/abs/2016AM-282017
© Copyright 2016 The Geological Society of America (GSA), all rights reserved. Permission is hereby granted to the author(s) of this abstract to reproduce and distribute it freely, for noncommercial purposes. Permission is hereby granted to any individual scientist to download a single copy of this electronic file and reproduce up to 20 paper copies for noncommercial purposes advancing science and education, including classroom use, providing all reproductions include the complete content shown here, including the author information. All other forms of reproduction and/or transmittal are prohibited without written permission from GSA Copyright Permissions.