T238 Beyond EARTHTIME: Accuracy and a Multi-Chronometer Time Scale (Posters)

Tuesday, 27 September 2016
9:00 AM - 6:30 PM
Exhibit Hall E/F

SUB-NANOGRAM NEODYMIUM ISOTOPE MEASUREMENTS ON A NEW ISOTOPX PHOENIX TIMS USING 10^11 AND 10^12 OHM RESISTORS

Paper number: T238-3
Program: Technical Sessions
Time: 9:00 AM – 6:30 PM

Authors

Abstract

The Earth and Environmental Sciences Dept. at Boston College recently acquired a new Isotopx Phoenix Thermal Ionization Mass Spectrometer (TIMS). The instrument was constructed in late 2015 into early 2016 and was delivered to Boston College in spring 2016. Initial isotope analyses of Nd standard JNdi-1 yield consistent and accurate results across differing aliquot sizes (300 ng Nd, 4 ng Nd, and 200-400 pg Nd), filament geometries (triple vs. single), analysis types (metal vs. oxide), and resistor arrays (10^11Ω vs. 10^12Ω). For 300 ng runs, standards are loaded on triple filaments with HNO3 and analyzed as Nd+ using an automated ramp sequence and a multidynamic method. The program was set to ramp and maintain a 4 volt 144Nd+ beam. The first 13 analyses yield an average 143Nd/144Nd = 0.512109±0.000005 (i.e. 10 ppm; 2SD) with an average internal precision of 3 ppm (2σ). The smaller 4ng and 400pg standards were loaded on outgassed single Re filaments with an H3PO4+Ta2O5 slurry activator solution and analyzed as NdO+ using a multidynamic method. The 4ng loads were also ramped automatically, and signal intensities of 3 volts 144NdO+ were maintained during measurements. The first 14 analyses of 4 ng loads yield 143Nd/144Nd = 0.512103±0.000004 (i.e. 8 ppm; 2SD) with an average internal precision of 5 ppm (2σ). The sub-nanogram sized loads were analyzed using a 10^12Ω resistor array. The filaments were ramped manually and signal intensities of approximately 2 volts (200mV 10^11Ω equivalent) 144NdO+ were utilized for measurements. The first fourteen analyses, spanning measurements made in the factory and after the instrument was installed at Boston College, yield 143Nd/144Nd = 0.512112±0.000014 (i.e. 28 ppm; 2SD) with an average internal precision of 13 ppm (2σ).

Our results demonstrate the ability of the Phoenix TIMS to accurately and consistently measure Nd isotopes of various aliquot sizes, including sub-nanogram loads on 10^12Ω resistors. We anticipate further improvements as we refine our run protocols, loading procedures, and calibrate our oxygen isotope composition for NdO+. High precision Nd isotopic analysis on sub-nanogram samples is crucial for precise Sm-Nd garnet geochronology. Garnet geochronology dating tectonometamorphic processes should represent another important component of the EARTHTIME effort.

Geological Society of America Abstracts with Programs. Vol. 48, No. 7

doi: 10.1130/abs/2016AM-284964

© Copyright 2016 The Geological Society of America (GSA), all rights reserved. Permission is hereby granted to the author(s) of this abstract to reproduce and distribute it freely, for noncommercial purposes. Permission is hereby granted to any individual scientist to download a single copy of this electronic file and reproduce up to 20 paper copies for noncommercial purposes advancing science and education, including classroom use, providing all reproductions include the complete content shown here, including the author information. All other forms of reproduction and/or transmittal are prohibited without written permission from GSA Copyright Permissions.