T183 Karst Processes and Speleology (Posters)

Tuesday, 6 November 2018
9:00 AM - 6:30 PM
Halls J-K

A LABORATORY METHOD FOR MEASURING CARBONATE DISSOLUTION RATES

Paper number: T183-8
Program: Technical Sessions
Time: 9:00 AM – 6:30 PM

Authors

Abstract

Seldom do field observed dissolution rates of carbonates match theoretical calculations. The development of this new laboratory method attempts to reconcile this disparity by dissolving samples of carbonates in a uniform environment. Two calcite samples were prepared by cutting a small (~1 cm cube) of calcite and polishing it on one side while covering the other sides with marine epoxy and cyanoacrylate glue to control the surface area of the samples. On an individual basis, each sample was placed in a styrene cage which was then submerged in approximately 0.65 L of deionized water. During the experiment, CO2 was pumped into the water to ensure the saturation of H2CO3. Conductivity was also measured to observe the liberation of ions, namely Ca2+, from the sample. The beaker was placed on a stir plate to ensure even mixing of water and was sealed using a plastic beaker cover and parafilm. Each experimental trial was conducted over several days. Small aliquots of the beaker’s water were collected approximately every 12 hours, and later analyzed for Ca2+ concentration through atomic emission spectroscopy which was used to calibrate the conductivity - Ca2+ relationship, and from this dissolution rates of the samples can be calculated.

During the course of these experiments it became apparent that liquid-based probes and even gel-based probes inherently leak buffer solution, making them unsuitable when conductivity is also being measured over long periods of time. This prohibits the use of pH probes or ion-selective electrodes for either calcium or magnesium which would have removed the need for atomic emission spectroscopy. Preliminary results from several trials show a dissolution rate of about 1000 cm*ka-1 (±6%) for a calcite sample in a uniform and H2CO3-saturated solution; which is not outside the realm of reason given the idealized nature of the experimental design.

Geological Society of America Abstracts with Programs. Vol. 50, No. 6

doi: 10.1130/abs/2018AM-317648

© Copyright 2018 The Geological Society of America (GSA), all rights reserved. Permission is hereby granted to the author(s) of this abstract to reproduce and distribute it freely, for noncommercial purposes. Permission is hereby granted to any individual scientist to download a single copy of this electronic file and reproduce up to 20 paper copies for noncommercial purposes advancing science and education, including classroom use, providing all reproductions include the complete content shown here, including the author information. All other forms of reproduction and/or transmittal are prohibited without written permission from GSA Copyright Permissions.