T168 Geologic Energy Research (Posters)

Tuesday, 6 November 2018
9:00 AM - 6:30 PM
Halls J-K

QUANTITATIVE EVALUATION OF ADSORBED/FREE SHALE OIL: EXPERIMENTS AND MODEL STUDIES

Paper number: T168-4
Program: Technical Sessions
Time: 9:00 AM – 6:30 PM

Authors

  • Pengfei Zhang Presenting Author
    China University of Petroleum (East China), Qingdao
  • Shuangfang Lu
    China University of Petroleum (East China), Qingdao
  • Junqian Li
    China University of Petroleum (East China), Qingdao

Abstract

Shale oil is primarily present in shale pores as adsorbed oil and free oil (movable oil and irreducible oil). The shale oil at three occurrence states has different thermodynamic characteristics. Movable oil is retained in a free status in larger pores and has a normal vapor pressure, while oil adsorbed on pore surface has a lower vapor pressure than normal. Thus, the three states of oil in shale pores can be quantitatively characterized by evaporation experiments. In this study, evaporation experiments simultaneously with NMR tests were conducted for 13 oil-saturated (n-dodecane) shales. The adsorbed oil contents of 13 shales range from 2.75 mg/g to 17.61 mg/g (mean 8.40 mg/g). The irreducible oil content is between 1.69 mg/g and 6.43 mg/g (mean 4.25 mg/g) and the movable oil contents vary from 0 mg/g to 20.61 mg/g (5.89 mg/g). The average value of adsorption proportion (ra) is 0.497, ranging from 0.237 to 0.699. NMR T2 spectra show that movable oil is mainly retained in meso- (0.1 μm~1 μm) and macropores (>0.1 μm); irreducible oil is mainly confined in mesopores; and adsorbed oil is predominant in micro- (<0.1 μm) and mesopores. According to the quantitative evaluation model for hydrocarbon adsorbed and free oil in the authors’ previous work, the shale oil ra evaluation model can be determined as: 1000V/S=dm=(ρa/ρf)H(1/ra-1)+H (where V and S are the pore volume and surface area, respectively; dm is the equivalent pore diameter; ρa and ρf are the densities of adsorbed and free oil, respectively; H is the thickness of the oil adsorbed on the pore surface). The ρa/ρf and H values can be obtained as 2.0802 and 0.723 nm, respectively, based on the measured ra values. The adsorbed and free oil contents can be obtained from NMR T2 spectra and the calculated ra values correspond well with measured values with a high correlation coefficient of 0.92. And the calculated adsorbed oil T2 spectra are well consistent with the measured T2 spectra, indicating that ra evaluation model combined with NMR T2 spectrum can effectively evaluate the adsorbed oil content of shale oil and the ra for pores at different scales. In this study, the quantitative evaluation method for adsorbed and free shale oil was established, which can be used to determine the adsorbed and free shale oil contents by combining with NMR T2 spectrum.

Geological Society of America Abstracts with Programs. Vol. 50, No. 6

doi: 10.1130/abs/2018AM-319135

© Copyright 2018 The Geological Society of America (GSA), all rights reserved. Permission is hereby granted to the author(s) of this abstract to reproduce and distribute it freely, for noncommercial purposes. Permission is hereby granted to any individual scientist to download a single copy of this electronic file and reproduce up to 20 paper copies for noncommercial purposes advancing science and education, including classroom use, providing all reproductions include the complete content shown here, including the author information. All other forms of reproduction and/or transmittal are prohibited without written permission from GSA Copyright Permissions.