T65 3D Printing for Geoscience and Engineering: Emerging Technology in Education, Research, and Communication

Tuesday, 27 October 2020
10:00 AM - 12:00 PM
Meeting Rooms

FAST, CHEAP, AND REPEATABLE TWO-PHASE FLOW EXPERIMENTS USING 3D PRINTED MICROFLUIDIC DEVICES

Paper number: T65-6
Program: Technical Sessions
Time: 11:15 AM – 11:30 AM

Authors

Abstract

Understanding of the various mechanisms occurring during multiphase subsurface processes such as CO2 dissolution and snap-off events is vital to optimise large scale processes such as CO2 sequestration, improved oil recovery and energy storage. Recent advances in three-dimensional (3D) printing allows for cheap and fast manufacturing of complex porosity models, allowing investigation of specific flow processes in repeatable manner and enabling sensitivity analysis for small geometry alterations. Yet there are concerns regarding dimensional fidelity, shape conformity and surface quality, and therefore the printing quality and printers’ limitations must be benchmarked. Direct Numerical Simulations (DNS) allows for numerical investigation of interfacial mass transfer during CO2 dissolution processes. Yet there is lack of experimental work that can validate the existing models.

We present an experimental investigation into the ability of 3D printing to generate custom-designed micromodels accurately and repeatably down to a minimum pore throat size of 140 μm, which is representative of the pore-throats seen in coarse sandstones. Particle Image Velocimetry is used to compare the velocity map obtained from one-phase flow experiments in 3D printed micromodels with the map generated with direct numerical simulation (OpenFOAM software) and an accurate match is obtained. Furthermore, we use the 3D printed micromodel to investigate the dissolution of a trapped CO2 gas bubble in a single pore to observe the impact of the pore geometry on the dissolution rate of the bubble. This experimental work can be used to validate Direct Numerical Simulation models. Our investigation suggests that 3D printed micromodels can be used for fast and cheap prototyping of flow experiments, and to investigate the physics of two-phase systems, including the occurrence of snap-off events, the impact of viscosity ratio, and the effect of gas solubility in water.

Geological Society of America Abstracts with Programs. Vol. 52, No. 6

doi: 10.1130/abs/2020AM-357162

© Copyright 2020 The Geological Society of America (GSA), all rights reserved. Permission is hereby granted to the author(s) of this abstract to reproduce and distribute it freely, for noncommercial purposes. Permission is hereby granted to any individual scientist to download a single copy of this electronic file and reproduce up to 20 paper copies for noncommercial purposes advancing science and education, including classroom use, providing all reproductions include the complete content shown here, including the author information. All other forms of reproduction and/or transmittal are prohibited without written permission from GSA Copyright Permissions.