T102 Environmental and Engineering Geology Division: Poster Session for Graduate and Undergraduate Students (Posters)

Monday, 23 September 2024
8:00 AM - 5:30 PM
Hall D

MODELING THERMAL FLUX THROUGH A NORMAL FAULT DAMAGE ZONE WITH ENHANCED PERMEABILITY: IMPLICATIONS FOR GEOTHERMAL ENERGY PRODUCTION

Paper number: T102-1
Program: Technical Sessions
Time: 8:00 AM – 5:30 PM

Authors

Abstract

Geothermal energy supplies less than 2% of the renewable energy produced in the US. Geothermal resources have been limited because traditional systems require natural fluids, high permeability, a seal, and high heat flow. Most such systems are located near tectonic boundaries or magmatic bodies and consist of fractured hot wet rock. However, most non-magmatic heat sources are concentrated in deeper hot dry rock (HDR) systems that lack sufficient fluids and permeability. Fault damage zones, volumes of fractured rock adjacent to faults, may have sufficient heat flow but lack sufficient permeability. To address this limitation, energy can be extracted from HDR thermal reservoirs by an Enhanced Geothermal System (EGS). EGS greatly reduces geographical limitations on geothermal energy in the US, especially because so many normal faults in the Basin and Range Province are associated with high heat flows.

EGS uses directional drilling and hydraulic fracturing (HF) to create a cylindrical channel of high permeability. Cold fluid is pumped into the channel by an injection well, gains thermal energy in the channel, and is drawn out by an extraction well to be used to generate energy. The channel has a fluid flux that is highest in the center and decreases radially because just as permeability in a damage zone decreases with distance from the fault, permeability in the channel decreases with distance from the borehole.

We investigate fluid flow and thermal flux within a simplified EGS by modeling the system as an hydraulic fractured cylindrical channel. The model consists of nested cylinders with radially decreasing permeability and radially increasing thermal conductivity (rock is more conductive than water). We use Matlab and Simulink to solve the coupled partial differential equations governing thermal and fluid flow. We use Darcy’s law to determine the fluid flux as a function of distance from the borehole and the heat equation to determine the thermal flux as a function of the distance from the borehole. These results allow us to determine the total thermal flux flowing out of the system at the extraction well. This allows us to investigate the impacts of differing permeability and radii ranges on the productivity of the theoretical system.

Geological Society of America Abstracts with Programs. Vol. 56, No. 5

doi: 10.1130/abs/2024AM-401014

© Copyright 2024 The Geological Society of America (GSA), all rights reserved. Permission is hereby granted to the author(s) of this abstract to reproduce and distribute it freely, for noncommercial purposes. Permission is hereby granted to any individual scientist to download a single copy of this electronic file and reproduce up to 20 paper copies for noncommercial purposes advancing science and education, including classroom use, providing all reproductions include the complete content shown here, including the author information. All other forms of reproduction and/or transmittal are prohibited without written permission from GSA Copyright Permissions.