24 D7. Structural Geology, Geophysics, Tectonics, and Petrology Contributions (Posters)

Saturday, 29 March 2025
8:30 AM - 5:30 PM
North Great Hall

AN INVESTIGATION INTO A FAULT DAMAGE ZONE IN THE TRIASSIC NEW HAVEN ARKOSE, SIMSBURY, CONNECTICUT

Paper number: 24-4
Program: Technical Sessions
Time: 8:30 AM – 5:30 PM

Authors

  • Kaitlyn Cannon Presenting Author
    Central Connecticut State University, New Britain, CT
  • Mark A. Evans
    Central Connecticut State University, New Britain, CT

Abstract

An outcrop of the Triassic New Haven Arkose in Simsbury, Connecticut contains a 10 m wide fault zone containing a series of closely-spaced normal faults striking ~194°. The outcrop is mostly composed of arkose sandstone and arkose siltstone that strike ~000° and dip ~15° east. Numerous small (<1m long) incipient normal faults define a damage zone extending ~ 60 m to the west and at least 10 m to the east of the fault zone. The incipient faults strike 195° to 222° and dip 40° to 80° to the west. In addition, there are numerous fractures that are sub-perpendicular to bedding and strike 180° to 190°. The two fracture sets that are found in these rocks may be related to two different deformation events. The incipient faults striking 195° to 222° are interpreted to be related to the ‘Drifting’ phase of the break-up of Pangea. The other fracture set striking 180° to 190° implies a ~N-S compressive stress and may be related to a transition to the ‘Shifting’ phase of the Pangea break-up.

The mechanical stratigraphy of the outcrop was determined to investigate the relationship to the fracturing and faulting. The hardness of the rock was tested with a Schmidt hammer as a proxy for rock strength. The gamma-ray response was measured with a RS-230 hand-held spectrometer. A 45-meter-long synthetic well log was created with a data spacing of 20 centimeters. The fine-grained siltstones and shales generally have a low hardness (<20 Schmidt Hammer units) and a generally high gamma-ray count (350-450). This is likely due to the higher clay mineral content that may be associated with uranium and thorium accumulation. In contrast, the coarse-grained rocks generally have a high hardness (>40 Schmidt Hammer units) and a generally low gamma-ray count (<350). Fracture spacing is both lithology and bed thickness dependent. Siltstones generally have a fracture spacing of 0.4 to 0.74 m, while sandstones have a spacing of 0.09 to 0.62m. thicker sandstone beds have a wider spacing than thinner sandstone beds. The incipient normal faults exhibit a distinct relationship to the mechanical layering where the segments of the fractures that pass through siltstone layers have a lower dip than those that pass through the sandstone layers. Understanding mechanical-stratigraphical relationships are important for characterizing subsurface groundwater and hydrocarbon fluid flow.

Geological Society of America Abstracts with Programs. Vol. 57, No. 3

doi: 10.1130/abs/2025NE-407604

© Copyright 2025 The Geological Society of America (GSA), all rights reserved. Permission is hereby granted to the author(s) of this abstract to reproduce and distribute it freely, for noncommercial purposes. Permission is hereby granted to any individual scientist to download a single copy of this electronic file and reproduce up to 20 paper copies for noncommercial purposes advancing science and education, including classroom use, providing all reproductions include the complete content shown here, including the author information. All other forms of reproduction and/or transmittal are prohibited without written permission from GSA Copyright Permissions.