227 Recent Advances in Glacial Geology, Geomorphology, and Chronology (Posters)
We invite papers on topics related to glacial systems, landforms, and chronology, especially work that has connections to (i) interpretations of past climates and/or (ii) surficial geology and resource extraction.
Tuesday, 21 October 2025
8:00 AM - 5:30 PM
HBGCC, Hall 1
How does supraglacial debris grain size influence surface lowering on Emmons Glacier, Mount Rainier, WA?
Paper number: 227-3
Program: Technical Sessions
Time: 8:00 AM – 8:00 AM
Authors
-
Angel Bahena Gomez Presenting AuthorCalifornia State University, San Bernardino, San Bernardino, CA
-
Lilianna NunezCalifornia State University, San Bernardino, San Bernardino, CA
-
Karina RamirezCalifornia State University, San Bernardino, San Bernardino, CA
-
Claire ToddCalifornia State University, San Bernardino, San Bernardino, CA
Abstract
Mount Rainier is a 14,410’ active volcano in Washington State, home to 28 glaciers. The largest, Emmons Glacier, covers 4.23 mi² and advanced in the late 20th century, a change attributed to a 1963 rockfall from Little Tahoma Peak that blanketed its lower surface with debris. Supraglacial debris can significantly alter melt rates and mass balance by either insulating the ice or enhancing melting depending on debris thickness and the grain size of the sediment covering the ice. This project investigates how the grain size of supraglacial debris influences surface lowering on Emmons Glacier. Previous work on debris covered glaciers shows that grain size affects debris thermal properties, with finer material providing stronger insulation and coarser material allowing greater heat penetration. Although studies on Emmons Glacier have documented substantial surface elevation lowering in recent decades, the relationship between supraglacial debris grain size and melt remains underexplored. A total of 75 sediment samples were collected over three summers to characterize the grain size of debris covering the glacier. At 48 sites, pits were dug to the ice surface or until the pit walls became unstable and collapsed, preventing further digging. Sediment samples were collected at the surface, base, and at intermediate depths where sediment changes were visible. In the laboratory, samples were dried, weighed, and sieved to quantify grain size distribution. Weight percentages for each fraction were calculated, and grain size distribution curves were generated. These measurements were compared with high-resolution surface elevation profiles to examine how debris characteristics relate to patterns of surface lowering and glacier surface morphology. We expect that finer, more weathered material is located along the glacier margins where ice flow rates are slower and debris has been exposed for longer; and coarser, less weathered material towards the glacier centerline, where debris is recently delivered to the surface. This variation in grain size likely influences melt rates, as finer material at the margins may provide stronger insulation, while coarser material in central areas allows greater heat penetration and enhanced melt.
Geological Society of America Abstracts with Programs. Vol. 57, No. 6
doi: 10.1130/abs/2025AM-412865
© Copyright 2025 The Geological Society of America (GSA), all rights reserved. Permission is hereby granted to the author(s) of this abstract to reproduce and distribute it freely, for noncommercial purposes. Permission is hereby granted to any individual scientist to download a single copy of this electronic file and reproduce up to 20 paper copies for noncommercial purposes advancing science and education, including classroom use, providing all reproductions include the complete content shown here, including the author information. All other forms of reproduction and/or transmittal are prohibited without written permission from GSA Copyright Permissions.